Everytime i come across a 3d printing post
-
Think of the animals that preceded us. Humans are so self-absorbed.
I’m hope you held a pinky up as you typed that so you could get the full “I’m better than everyone else” experience
-
I’m hope you held a pinky up as you typed that so you could get the full “I’m better than everyone else” experience
Nope, I fed my pinkies to the starving kittens at the end of the street.
-
tbf what matters here more is microplastic production per capita rather than overall production
wrote last edited by [email protected]Which is much lower for 3d printers, than it is for cars :3
-
made from doesn't mean same properties (e.g. biodegradability)
It's biodegradable in an industrial composter, and degrades in sunlight. Sure it's not perfect, but compared to everything else its impact is minimal.
-
Tires are the 2nd largest contributor to microplastics in the ocean. Synthetic fabric like nylon, polyester, etc. are the main contribution.
And the majority of that is fishing nets. I’ll keep my printer thank you.
-
5mm what's that like ten inches?
wrote last edited by [email protected]5 Millemiles.
-
Do you rather have me buying a complete new device than printiner a spare part with PLA (not derived from oil)?
You see, injection molding in a factory and shipping it is far superior to printing it at home.
-
tbf what matters here more is microplastic production per capita rather than overall production
That is what's referred to as 'a distinction without a difference'.
-
This post did not contain any content.
PLA is made from corn, sugarcane and other plants. Don't get it twisted.
-
That is what's referred to as 'a distinction without a difference'.
what's your opinion on private jets?
-
Which is much lower for 3d printers, than it is for cars :3
yeah probably, im not debating that (open source 3d printing is one of the best innovations in recent years fight me)
-
PLA doesn't not hold up to the elements. sunlight breaks it down
it turns to floppy noodle in summer heat
do you even know anything about PLA?
sorry for spez site but here you go
I use PLA all the time and I get that it degrades in sunlight, but every fucking plastic does. Degradation isn't decomposition and you can still enjoy 3D printing while understanding that it's not 100% environment friendly
-
what's your opinion on private jets?
Nobody should have a private jet
How is that relevant to the topic of microplastics? Outside of tires, which again — see my first point.
