Poor Performance in The Finals with Nvidia RTX 3060 Ti (Worse than RX 580)
-
I recently upgraded from an RX 580 to an RTX 3060 Ti, but The Finals now runs significantly worse than before. I’m getting around 40 FPS with frequent micro-stutters, making it nearly unplayable for competitive play.
This issue only occurs with The Finals, all other games, including other Steam titles, run fine.
It also doesn’t matter what settings I use. The game runs at 40 FPS whether I set everything to Ultra or drop to Low with DLSS on Ultra Performance.
The best performance I’ve managed (around 40–50 FPS) is using the following launch flags:
mangohud gamemoderun %command%Here’s what I’ve tried so far (without success):
- Tested Proton Hotfix, Experimental, Proton GE, and Proton EM (both Flatpak and native).
- Ran the game with and without GameMode, MangoHUD, and Gamescope.
- Updated drivers and system packages to the latest versions.
None of these made any improvement. Some configurations even caused the game not to launch at all.
-
I recently upgraded from an RX 580 to an RTX 3060 Ti, but The Finals now runs significantly worse than before. I’m getting around 40 FPS with frequent micro-stutters, making it nearly unplayable for competitive play.
This issue only occurs with The Finals, all other games, including other Steam titles, run fine.
It also doesn’t matter what settings I use. The game runs at 40 FPS whether I set everything to Ultra or drop to Low with DLSS on Ultra Performance.
The best performance I’ve managed (around 40–50 FPS) is using the following launch flags:
mangohud gamemoderun %command%Here’s what I’ve tried so far (without success):
- Tested Proton Hotfix, Experimental, Proton GE, and Proton EM (both Flatpak and native).
- Ran the game with and without GameMode, MangoHUD, and Gamescope.
- Updated drivers and system packages to the latest versions.
None of these made any improvement. Some configurations even caused the game not to launch at all.
wrote last edited by [email protected]Which nvidia driver you're using? If you're using the regular old nvidia blob, you might want to try disabling the gsp firmware. But note that this can't be done with nvidia-open, only on nvidia.
Previously the gsp firmware was a bit problematic on some systems and wayland, disabling it solved some issues. But it has been fine since the 575 drivers, at least for me (rtx3090)
