I couldn't find a suitable door threshold, so I made one
-
This post did not contain any content.
-
D [email protected] shared this topic
-
Looks better than anything you could've bought at the store; nicely done!
-
Thank you Friend!
-
Nice work!
-
Is that treated/engineered bamboo laminate flooring? I think I have the exact same stuff from Home Depot.
-
Very nice! How did you go about it?
-
I'm curious about this too, I've been trying to find an aluminum threshold I can modify but this might be easier.
-
In my area I see old beds thrown out pretty regularly. I try to collect the bed rails since they're usually made from a single piece of maple or oak. I've made a few thresholds from them.
-
Very nice
-
-
-
-
-
I've been looking for an excuse to buy one for a while.
-
Dropping a few brads/nails into it to hold it into place is a good idea. As time goes by, wear and expansion/contraction of the flooring will have it popping out.
I picked up an airgun to put in 2 1/2" finishing brads on the floors I did (engineered hickory). Turned the air pressure up to the maximum the gun was rated for (150psi) and sunk the brads into the board
-
not dull at all!
-
That's a good idea, thanks!
-
You’d at least need access to a router to make this.
It could be done with a saw and a block plane.
-
I'm just wondering, is it common to have that big a gap under your doors where you are?
I'd stub my toe on that, fuck me
-
Showing any type of skill at craftsmanship is veering way out of dull territory.
I may have to go lie down for a bit.
