Got myself some energy monitoring Zigbee plugs and made an interesting discovery
-
[email protected]replied to [email protected] last edited by
Ah, but only one is a chest freezer
That, and I used to have a freezer that was a power suck.
-
[email protected]replied to [email protected] last edited by
The PC is effecient. It's not a gaming PC. It idles at around 16W and maxes out at 80'ish.
-
[email protected]replied to [email protected] last edited by
Place a surge protector between the smart plug and the PC to be safe.
What benefit does this serve in this situation?
-
[email protected]replied to [email protected] last edited by
I discovered a similar issue. PC desk was using 8-9W when the PC was turned OFF! My power strip was taking a bit under 1W (the little light, old), two smart bulbs as well but I'll allow those losses. An older Logitech speaker setup (2+1) was taking 6-7W, turned off! Crazy.. and illegal if it were made today (in EU). So this is completely wasted energy in my opinion.. started disconnecting the whole desk now.
For comparison, my home server is averaging 7-8W, turned on all the time:
-
Those days were at worst almost 10 years ago.
Stop living in the past with those situations.And you get an SSD.
And YOU get an SSD.
And you fine sir also get an SSD! -
[email protected]replied to [email protected] last edited by
At least until MS muddied the waters with "hibernate".
-
[email protected]replied to [email protected] last edited by
Ah shit, I need 240v lol
-
[email protected]replied to [email protected] last edited by
36 Watts idle sounds like a lot for a 5800X3D. I'll see what my 5700X3D does, never checked that. Not in software and not at the wall.
-
[email protected]replied to [email protected] last edited by
Just fyi, Watts is a measure of power, and WattHours is power over time. So your home network and server consume 130w, which would be 130wh after an hour, or 3120wh after a day. The chest freezer would be 400wh in a day, rather than 400w in a day.
-
[email protected]replied to [email protected] last edited by
Most rented bedrooms in my area dont even have built-in lighting. Its all floor and table lamps, usually on a smart outlet these days
-
[email protected]replied to [email protected] last edited by
Thanks for the heads up, I often let the time slip when casually talking about stuff like this.
Actually the server and network consumes 130Wh or around 3120Wh a day, while my freezer consumes 400Wh per day or around 16Wh. That's also the reason why I was shocked about the consumption, as you would guess a freezer takes more.
-
[email protected]replied to [email protected] last edited by
What are you running your server on?
-
[email protected]replied to [email protected] last edited by
Fail safe. It'll trip the power before it hits the wall and burns the house potentially limiting a fire or containing whatever did happen.
-
[email protected]replied to [email protected] last edited by
You're in the same boat as me, except swap 70's for 1920's. I have to tear down all the plaster -- not drywall, actual literal plaster, on lath -- to get at the ground floor wiring. I decided it's fine where it is for now.
-
[email protected]replied to [email protected] last edited by
Major issue lol short circuit or too thin of wire/breaker, old house probably. Instant dim and back to normal turning on a heavy appliance can happen as the power circuit lags but it's a mere fraction of a second.
So to turn on an appliance I'm pretty sure it takes 3000 watts to cycle on then reduces to say 1500 watts to operate a normal 1500w appliance. Nothing should ever continuously dim lights. Major fire hazard if so.
-
[email protected]replied to [email protected] last edited by
Windows is gonna Windows. Even if you did track down the issue your one update from a borked system or square one when they alter the setting and relocate it on their own accord.
-
[email protected]replied to [email protected] last edited by
Easy to miss typing in a hurry too. I just did it above.
-
[email protected]replied to [email protected] last edited by
Yeah I made a similar discovery after installing a Shelly Switch with Power Metering. The monitors and their brightness make a huge difference as well when in or near idle (for photography, so not a surprise). I've also implemented an "anti-standby" function, so the switch opens whenever the current falls under a specific threshold.
For the WoL, since I have a switch, I configured my BIOS so it would turn on after power loss. Now I can start to boot up from afar
-
[email protected]replied to [email protected] last edited by
Older speakers like that use always on transformers, constantly wasting energy to keep the core energized. You're correct those cannot be made any more, they must use efficient switch mode supplies.
-
[email protected]replied to [email protected] last edited by
Yeah at some point you just say fuck it and limp along until the problem is big enough that it's time for a completely new house or you move.
In our situation it's one of those things where it just doesn't seem worth it to properly address because if we are gonna have an electrician cut a bunch of holes in our walls to redo all the wiring we may as well have a plumber cut a bunch of holes in our ceiling to insulate all the pipes they installed in the ceiling crawl space without any insulation. And if we have them cutting holes in every wall and every ceiling we may as we lost have them tear the whole goddamn house down and start over properly lol.