How to clean airfryer basket?

[dannyboy@sh.itjust.works]

Hand wash with soap after each use? What are people saying in the comments about built up oil?

[geneva_convenience@lemmy.ml]

Hand wash with soap after each use

https://www.youtube.com/watch?v=waEC-8GFTP4

[geneva_convenience@lemmy.ml]

baking soda did nothing

soap did nothing

trying a dishwasher tablet next

[sergeantsushi@lemmy.world]

Soak the basket in 50% vinegar: water. Then run the air fryer with some vinegar in it to clean out the rest of it.

Vinegar is an acid which works great on grease.
Baking soda is basic and works great on carbon build ups.

[pcr3@lemmy.world]

Post a picture of it, the basket and the mesh.

If it's really bad then like someone else suggested: get some oven degreaser from the store, spray it down, let it sit for 10 minutes and wash off with hot water. Try not to breath the stuff, it's nasty.

But you should be cleaning it weekly. Warm it up for a minute or two, then with folded paper towels wipe it out over a trash can. Leaving a light coating is actually to your advantage, it will keep the new stuff from sticking.

[sonor@lemmy.world]

Maybe, but it’s gross as duck

[blackbrook@mander.xyz]

One common, readily available, relatively unharmful type is citrus decreasers like Citrisolv or similar.

[readmorebooks@lemmy.zip]

Get the dangerous alkaline concentrate and dilute it as directed for the situation. It's much cheaper. Whatever environmental concerns are canceled out because 1 gallon was transported instead of 64-128 gallons.

[blackbrook@mander.xyz]

I buy the orange stuff by the gallon because I can use it for bike chain degreasing, and woodworking ( as a solvent for oil finishes, etc.), etc.

[readmorebooks@lemmy.zip]

When we want to break hydrocarbon chains we use bases by default. But, I'd not use a base on a bike chain because if it rusts even a little bit it's junk.

For woodworking why is this better than mineral spirits?

[blackbrook@mander.xyz]

I don't know about 'better', but I prefer it for being less fumey, I feel better about occasionally getting some on my skin, and prefer not using petroleum derivatives. I know there's low fume mineral spirits and I've used that for paint cleanup, but i'm not confident it behaves the same for finishes.

[readmorebooks@lemmy.zip]

That makes sense. I'll give it a try. Thank you for teaching me.

[tunalobster@lemmy.world]

The blue sponges that ate for non stick are softer than the normal green ones. The rough side of the blue ones are safe for non stick assuming your aren't giving it everything you've got.

These ones:

[geometrinen_gepardi@sopuli.xyz]

Eating bits of teflon is harmless.

[geneva_convenience@lemmy.ml]

[annafrankfurter@lemmy.ml]

Simple pick up your airfryer and throw it outside the window